MPF-B430P-MJ74BA

The MPF-B430P-MJ74BA is a food grade servo motor in the MP Series of products. The company known as Allen-Bradley, produced and manufactured this particular servo motor. The Allen-Bradley MPF-B430P-MJ74BA servo motor was designed to meet the demands and achieve goals within the applications of various machines and applications within the food, and even beverage, industry. This motor is equipped with many features that help it perform the tasks that it needs to accomplish. These features include food grade paint, shaft seal, premium permanent magnet technology, and even noncorrosive fasteners. This product is also designed using stainless steel to help meet and beat the tough demands set forth by the food and beverage industry. This servo motor is suitable to use with meat and poultry products and even application that involve high pressure or even chemicals. The frame size of this motor measures 115 (one hundred fifteen) millimeters (mm) and it has a three (3.0) inch stack length. 

The rated speed of the Allen-Bradley MPF-B430P-MJ74BA is 5000 (five thousand) rpm. The rated output of this product is 2 kW. This servo motor is classified as a four hundred and sixty (460) volt motor. Equipped with this product is a multi-turn high resolution encoder and it also has Type FF mounting holes. The stall torque of this food grade servo motor comes in at 6.55 Nm, or fifty-eight (58) pounds to an inch, continuous. The peak stall torque of this product, however, comes in at around 19.8 Nm, or one hundred and seventy-five (175) pounds to an inch. For the Allen-Bradley MPF-B430P-MJ74BA, the temperature range recommended for operation is from zero (0) to forty (40) °C, or 32 to 104 °F. 

The MPF-B430P-MJ74BA can operate with a sustained shaft load. With a 20,000-hour bearing fatigue life, the radial load force rating is 49 kg (108 lb). The axial load force rating with a maximum radial load force is 19 kg (42 lb), while the axial load force rating with zero radial load is 25 kg (55 lb). This 20,000-hour life does not consider the possible application-specific life decrease that can occur because of the motor bearing grease contamination from outside sources. This servo motor comes with a spring-set holding brake as its braking option. The brake will release when voltage is applied to the motor's brake coil. Operators must provide a second power source in order for the brake to be disengaged. This power source can be applied by a servo controller or manual operator control. The holding brake can be used occasionally as a stopping brake if the system's primary power source fails. However, this creates rotational mechanical backlash than can cause damage to the system, increase brake wear, and reduce the life of the brake. The holding brake is designed to hold a motor shaft at 0 rpm for up to the rated brake holding torque. The holding torque of the brake on the MPF-B430P-MJ74BA is 10.2 N-m (90 lb-in). The max backlash with the brake engaged is 37 arc minutes and the coil current at 24 VDC is 0.576-0.704 A. The brake also registers low brake response times, with the release registering at 110 ms. The MPF-B430P-MJ74BA can operate within a temperature range of 0-40 degrees Celsius (32-104 degrees Fahrenheit), while users can store the servo motor in a temperature range of -30-70 degrees Celsius (-22-158 degrees Fahrenheit).