The IC693PTM101 is a temperature control module which is manufactured and branded by GE Fanuc and Emerson. This module has small components like a processing unit, interfacing board, and a one-meter interfacing cable. Input transformers are provided with a PTM interface. The one-meter cable is used for the management of interfacing with the power transducer module and interface board. A series 90-30 Programmable Logic Controller (PLC) module is one of the main components of PTM that uses data for data reporting, general controlling, control of fault monitoring, and demand charge reduction with load shedding applications. This GE Fanuc and Emerson unit weighs 3.00 Pounds.

This IC693PTM101 power transducer module runs with a voltage input of 10.0V to 120.0V of alternating current and has an input current range of zero (0) Amperes to 7.5 Amperes RMS with a frequency range from 35 to 70 Hertz. The module processes computations of data at a rate of 20 milliseconds at an operating frequency range of 50.0 Hertz and 16.67 milliseconds at a rate of the frequency range at 60.0 Hertz. Reactive power and active power are observed in each phase for energy analysis with a summation of Watts, VAR, and total energy consummation. The diagnostics feature enables easy troubleshooting and faster processing with status support. Indicators are also available in the module that includes Module heartbeat, the valid voltage in a utility phase, valid phase polarity, valid voltage, and valid current measurements. Four hundred (400) milliamperes of current is consumed by the module at 5.0 Volts of direct current. The range of voltage is 10.0 to 150.00 Volts (alternating current) RMS in monitor mode with a nominal voltage of 120 Volts AC. Maximum total power dissipation is approximately 4.0 Watts in this power transducer module.